Cart is empty
CHECK OUT OUR NEW SITE !!
LAN & USB Cable Tester
Quick and easy testing of USB and network cables!
This cable tester is a compact, palm sized unit for testing USB and network cables. It can be used to read and check the pin-out configuration of cables before and after installation. A separate passive module is included for remote testing of pre-installed cables.
- Auto/manual scan modes
- Separate status LED for each wire
- Tests the following cables: USB (Type A/A, Type A/B), RJ-45 (UTP/STP), BNC, Co-axial and RJ-11/RJ-12 modular cables
- Supports the following standards: EIA/TIA 568A/568B, AT&T 258A, ISDN, 10Base-2, 10Base-T, 100Base-TX, 1000Base-T, Token Ring
- Carry case included
- Requires 9V PP3 battery
- Dimensions: 65 x 137 x 30mm (WxHxD)
LINDY
No posts found